Home :: Emergency Standby Generator :: PSS Accessories :: Air-Cooled Accessories

Air-Cooled Accessories

Air-Cooled Accessories
These high quality Winco accessories are compatible with our air-cooled Packaged Standby Systems.

Products

  •  per page
3/4" Vapor Fuel Strainer
SKU: 16243-000

If contaminants enter the fuel system of your Winco emergency standby system you will experience reduced power output and decreased reliability. Winco provides 40 microns of filtration with the demand regulator that is included standard on each air-cool Packaged Standby System. It is a wise investment to add the vapor fuel strainer. This device provides a redundant layer of protection to prevent troublesome contamination that can enter your fuel system from a variety of sources.

Set your own price!
Contact Dealer/Factory for pricing: $0.00
ASCO 185 Series, 100-400A, 2-wire Start
SKU: 97714-365

The ASCO 185 Series automatic transfer switch (ATS) are 2-wire control switches that are compatible with all 2-wire start systems from all manufacturers. The switch monitors incoming utility power. When the utility power fails it starts the generator and transfer the emergency load onto the generator. After the utility power is restored it will transfer the load back to the utility source, cool down the generator and then return to a standby mode. The ATS has an exercise circuit that tests the generator system every week. The automatic test feature can be set under load or under no load.

 

Contact Dealer/Factory for pricing: $0.00
ASCO 185 Series, 100-400A, 2-wire Start (Service Entrance Rated)
SKU: 97714-432

The ASCO 185 Series automatic transfer switch (ATS) are 2-wire control switches that are compatible with all 2-wire start systems from all manufacturers. The switch monitors incoming utility power. When the utility power fails it starts the generator and transfer the emergency load onto the generator. After the utility power is restored it will transfer the load back to the utility source, cool down the generator and then return to a standby mode. The ATS has an exercise circuit that tests the generator system every week. The automatic test feature can be set under load or under no load.

 

Contact Dealer/Factory for pricing: $0.00
Engine Oil Heater
SKU: 300484-5

WINCO air-cooled emergency standby generators use high quality engines that are capable of starting in cold temperatures. In order to ensure quick starting in the coldest environments WINCO has designed an engine heater kit that is field installed to keep your engine block warm. The kit includes a thermostat that engages the heater at 50 degrees F (internal cabinet temperature) and shuts off at 60 degrees F. The heating probe is produced by Kim Hot Start and is inserted into the oil pan replacing the second drain plug. The kit is powered from the factory installed duplex receptacle. To allow for the battery heater an additional NEMA 5-15 receptacle is included in the kit.

Contact Dealer/Factory for pricing: $0.00
Maintenance Kit
SKU: Maintenance Kit 0
Your generator requires regular maintenance. Our kits provide all of the necessary products to ensure your generator is ready when you need it most.
Set your own price!
Contact Dealer/Factory for pricing: $0.00
Small Battery Heater
SKU: 300484-3

The battery blanket prevents the battery from freezing and keeps it at an optimal operating temperature in cold environments. This battery heater kit plugs into the second factory installed receptacle or into the engine heater kit receptacle, depending upon the customer's specific configuration. The battery blanket is not a UL2200 listed option. The small battery blanket is compatible with all WINCO air-cooled emergency standby generators.

Set your own price!
Contact Dealer/Factory for pricing: $0.00
  •  per page